4.45 Heating Nozzle Setup - Tab1
4.45.1 Purpose
This mask is used to specify general settings for the nozzle heater and settings
for oil heating and oil cooling.
4.45.2 Description of the mask
Fig.4-49: Mask "Heating nozzle setup - tab1"
4.45.3 Description of the elements
General settings
Field Description
Group heating
Activates group heating. The single zones are heated within the
set tolerance values.
Optimize nozzle heating
Pre-selection for optimizing all heating zones.
● Finished
● Optimizing
The optimization itself is only started once this option has been
selected and the heater has been switched on. After optimization
has finished, the value will be set to 'Finished' automatically.
KePlast.HMI.KVB Description of the operating masks
© KEBA 2016
User's manual V3.05 119
To Next Page
Loading...
Need help?
General
