Keba Kemro K2 - 4.111 Calibration Pump for Plast; Purpose; Description of the Mask; Description of the Elements

4.111 Calibration pump for plast
4.111.1 Purpose
This mask can be used to manually calibrate the screw revolution and the back
pressure. Additionally the minimum and maximum output voltages for pressure
and velocity during the calibration can be set.
4.111.2 Description of the mask
The manual calibration of a sensor is done by entering values in a linearization
table.
Fig.4-117: Mask ''Calibration pump for plast"
4.111.3 Description of the elements
RPM
Name Description
Points Number of points in the linearization table.
Actual RPM
Displays the actual RPM (rotations per mi-
nute).
Start Index
Since only a maximum of 9 linearization points
can be displayed on the mask, this field serves
for navigation purposes. The input value al-
ways corresponds to the index of the element
displayed first. Example: Value 1: linearization
points 1 to 9 are displayed. Value 17: lineari-
zation points 17 to 25 are displayed, etc.
KePlast.HMI.KVB Description of the operating masks
© KEBA 2016
User's manual V3.05 217