Keba Kemro K2 User Manual

Information
In manual and adjustment mode the function Decompression after plasti-
cize will always be used.
Field Description
Mode
Mode of decompression, with the following selection options:
● No:no decompression.
● Time:decompression for a specified time duration.
● Position:decompression until a specified screw position.
Pressure
Specification of the pressure for the linear screw movement.
This field can only be edited when 'Time' or 'Position' mode has
been selected.
Velocity
Specification of the quantity for the linear screw movement.
This field can only be edited when 'Time' or 'Position' mode has
been selected.
Position / Time
Specification of the screw position or the duration of the decom-
pression. The display is dependent on the selected mode.
4.29 Plasticize - Tab Graphic
4.29.1 Purpose
This mask shows the pressure and velocity profile of the plasticize movement
graphically.
4.29.2 Description of the mask
The upper section of the mask displays the plasticize profile. Arrows on top of
the graphics display the direction of the profile. A red line in the graphics dis-
plays the actual position of the movement.
Further ramp settings for the respective movement can be set.
KePlast.HMI.KVB Description of the operating masks
© KEBA 2016
User's manual V3.05 91

Keba Kemro K2 Specifications

General

Brand	Keba
Model	Kemro K2
Category	Controller
Language	English