Keba Kemro K2 - 4.16 Ejector and Airvalve Settings

Field Description
Activate Mode
● No use: Coining deactivated.
● After inject: Coining starts after inject
● Inject position: Coining starts at a defined
inject position
● Inject pressure: Coining starts when a de-
fined inject pressure is achieved.
Inject Pressure
Coining starts if configured inject pressure is
achieved.
Inject Position
Coining starts if configured inject position is
achieved.
Delay time Delay time for starting coining.
4.16 Ejector and airvalves
4.16.1 Purpose
Settings for the ejector and the airvalves can be made in this mask.
4.16.2 Description of the mask
Besides the ejector's operating mode, this mask defines the force and velocity
for the ejector movements within different sections. The lower part of the mask
contains the settings for the arivalves.
Fig.4-18: Mask "Ejector" with transducer
Description of the operating masks
KePlast.HMI.KVB
© KEBA 2016
User's manual V3.0568