Keba Kemro K2 - Mold Setup Advanced - Tab2; Purpose; Description of the Mask

Ramp setup mode
Field Description
Ramp setup mode close
Ramp (pressure and velocity) in setup mode for mold close move-
ment is adjusted here.
Ramp setup mode open
Ramp (pressure and velocity) in setup mode for mold open move-
ment is adjusted here.
4.8 Mold Setup Advanced - Tab2
4.8.1 Purpose
Additional parameters for a rotary- resp. slide table can be configured within
this mask.
4.8.2 Description of the mask
Für the rotary- resp. slide table the minimum profile outputs and ramp settings
can be set.
Fig.4-10: Mask "Mold setup advanced tab 2"
Description of the operating masks
KePlast.HMI.KVB
© KEBA 2016
User's manual V3.0554