Keba Kemro K2 User Manual

4.6 Mold Setup - Tab2
4.6.1 Purpose
Additional parameters for the rotary- resp. slide table can be configured within
this mask.
4.6.2 Description of the mask
Maximum movement and movement delay times as well as the constant out-
puts for the rotary- resp. slide table movement in setup mode can be set.
Fig.4-8: Mask "Mold setup tab 2"
4.6.3 Description of the elements
Slide table / Rotary table setup mode output
Field Description
Slide in
Pressure and velocity output for slide table in movement in setup
mode.
Slide out
Pressure and velocity output for slide table out movement in setup
mode.
Rotate
Pressure and velocity output for rotary table movement in setup
mode.
Lock pin in
Pressure and velocity output for lock pin in movement in setup
mode.
Lock pin out
Pressure and velocity output for lock pin out movement in setup
mode.
Description of the operating masks KePlast.HMI.KVB
© KEBA 2016
User's manual V3.0550

Keba Kemro K2 Specifications

General

Brand	Keba
Model	Kemro K2
Category	Controller
Language	English