Keba Kemro K2 User Manual

4.84.3 Description of the elements
Contact information
Field Description
Contact to
Selection of the remote PC a connection should be established to.
The possible selections of remote PCs is configured on mask
"ServiceNet contact information".
Request from
Optional information about the person that requires a remote con-
nection. This information will be transferred to the remote PC when
establishing the remote connection. The possible selections are
configured on mask "ServiceNet contact information".
Connection status
Shows the actual connection status.
● Disconnected = no connection to a remote PC established.
● Request Ppending = a connection to a remote PC has been
established.
● Service Accepted = service request has been accepted by
the operator of the remote PC.
● Service Active = after the machine operator has confirmed
the remote connection (see "Confirm ServiceNet remote ac-
cess"), this connection status will be displayed.
Button Connect
Controller tries to establish a remote conenction to the remote PC
that is configured in input field "Contact to".
Button Disconnect Cancels the established remote connection.
Confirm ServiceNet remote access
If connection status is Service Accepted, a confirmation for remote access
will be requested from the remote PC. Following mask appears. By confirming
the request (OK- button), the connection status changes to Service Active.
By pressing the Back- button, the connection status will be reset to Discon-
nected.
Description of the operating masks KePlast.HMI.KVB
© KEBA 2016
User's manual V3.05174

Keba Kemro K2 Specifications

General

Brand	Keba
Model	Kemro K2
Category	Controller
Language	English