Keba Kemro K2 User Manual

Pressure controller (only displayed for drive master)
Field Description
P
Configuration of the proportional part for the
pressure controller. User can reduce the over-
shot by increasing the gain P. But this increa-
ses also the rising time.
I
Configuration of the integral part for the pres-
sure controller. User can reduce the rising time
by increasing the I.
Parameter set
Field Description
Load parameter to drive
Uploads the drive parameters that are currently
stored on the compact flash of the control to the
drive.
Save parameter from drive
Saves the actual drive parameters from the
drive on the compact flash of the control.
Reset Drive to Factory Settings
Resets the parameters of the drive to factory
settings.
Process
Shows the actual progress of the loading- resp.
saving- procedure.
AI pressure feedback offset
Field Description
Analog input offset
In order to compensate an possible Offset of
the system pressure, the value of the displayed
system pressure in standstill below has to be
entered.
System pressure
Actual deviation of the system pressure.
Single parameter transfer
With these settings it is possible to configure single drive parameters via control
system. The parameters can be requested from the control manufacturer on
demand.
Field Description
Object ID Object ID (decimal) of the drive parameter.
Sub ID Sub ID (decimal) of the drive parameter.
Data type
Data type of the drive parameter selected
above.
Read value
Reads and displays the drive parameter selec-
ted above.
Write value
Reconfiguration and writing of the read drive
parameter.
Description of the operating masks KePlast.HMI.KVB
© KEBA 2016
User's manual V3.05222

Keba Kemro K2 Specifications

General

Brand	Keba
Model	Kemro K2
Category	Controller
Language	English