Lucent Technologies FT-2000 OC-48 - Page 1002

NTP-005: Circuit Order 365-575-102
Page2of2 Issue8.0,July2002
Circuit Order: NTP-005---+---DLP-501-------Operation: NTP-002
|---DLP-511
|---DLP-514---+---DLP-512
| |---DLP-510-------DLP-512
|---Circuit Order: NTP-002
6. Repeat Steps 1 through 5 at the remote FT-2000
network element.
—
7. Wait until the NE ACTY LED goes off at both
FT-2000 end terminals (approximately 5 minutes).
—
8. If required to add DS3 port(s) to this OC-48 line at
this time, then refer to circuit order procedure.
CircuitOrder: NTP-002
DOITEMSBELOWINORDERLISTED....... FORDETAILS,GOTO