EasyManuals Logo

Lucent Technologies FT-2000 OC-48 User Manual

Lucent Technologies FT-2000 OC-48
1578 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #1016 background imageLoading...
Page #1016 background image
NTP-008: Circuit Order 365-575-102
Page 10 of 12 Issue 8.0, July 2002
15. Verify that the synchronization has been
provisioned for this “new node” and that it is
correct and consistent for this FT-2000 ring.
16.
NOTE:
Refer to Figure 5. The forced switch at the West node can now be
reset.
Instruct the technician at the West node to
enter FAULT-Switch-Line:1E:Reset to
reset the forced switch on line 1E. An alter-
native method is to remotely log in to the
West node and execute the command. The
line switch may cause traffic hits.
Reference: DLP-524
DOITEMSBELOWINORDERLISTED....... FORDETAILS,GOTO

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Lucent Technologies FT-2000 OC-48 and is the answer not in the manual?

Lucent Technologies FT-2000 OC-48 Specifications

General IconGeneral
BrandLucent Technologies
ModelFT-2000 OC-48
CategoryNetwork Hardware
LanguageEnglish