365-575-102 Circuit Order: NTP-009
Issue 8.0, July 2002 Page 7 of 8
12. Instruct the technicians, at both the West Node
and East Node, to wait one minute for the LEDs
on each node's receiver circuit pack to stop
flashing. If they do not stop flashing after about a
minute, refer to TAP-110.
13. Whenever the receiver's LEDs stop blinking--the
ring is then re-connected and a transient node
ID conflict condition will exist. Depending
on how many nodes are in the ring it may take
from several minutes to a few hours for this
condition to clear.
—
14.
NOTE:
Refer to Figure 5. The forced switch at the
West Node can now be reset.
Instruct the technician at the West Node to
enter FAULT-Switch-Line:1E:Reset
command at the CIT. The line switch may
cause traffic hits.
—
Figure 5 – Forced Switched Lines at the East Node and the West Node
DOITEMSBELOWINORDERLISTED....... FORDETAILS,GOTO
Line
1W
WEST
NODE
Line
1E
EAST
NODE
Other
Node(s)
Other
Node(s)
Line
1W
Line
1W
Line
1E
Line
1E
Line
1E
Line
1E
Line
1W
Line
1W
tpa 832684/01
DELETED
NODE
To Next Page
Loading...
Need help?
General