365-575-102 Operation: NTP-004
Issue 8.0, July 2002 Page 3 of 6
8. Delete any unnecessary slot-to-tributary (add)
cross-connections identified in Step 7. Use the
CONFIGURATION-Delete-Crossconnectio
n-STS3 (or STS1) command to delete a
cross-connection.
DLP-536
9.
NOTE:
This step is optional. If the cross-connection just deleted was to a slot
containing an OC-3 circuit pack, you may want to provision a DCC
assignment to remove DCC connectivity with the network element at
the other end of the OC-3 line.
You may delete a DCC assignment on an
OC-3 line.
DLP-542
10. At the CIT, select
CONFIGURATION-Retrieve-Crossconnect
ion-STS3 (or STS1) and execute to obtain
an STS3 (or STS1) Cross-Connection Map
Report. Section 11 shows examples of reports.
—
11. Verify that the cross-connection(s) in the report
matches those in the operation instructions.
—
12. Discontinue the login at the secondary node.
(To discontinue a remote login, refer to
DLP-524.)
—
13. Establish a login to the primary node identified in
Step 2. (To establish a remote login, refer to
DLP-524.)
—
14. The cross-connection(s) to be deleted and/or replaced at the primary node is
a 1-way-dri cross-connection(s).
At the CIT, select
CONFIGURATION-Retrieve-Crossconnect
ion-STS3 (or STS1) and execute to obtain
an STS3 (or STS1) Cross-Connection Map
Report.
—
DOITEMSBELOWINORDERLISTED........ FORDETAILS,GOTO
To Next Page
Loading...
Need help?
General