TAP-126: Trouble Clearing 365-575-102
Page2of2 Issue8.0,July2002
7. Go to the OPERATION: NTP-002 to install the same software release in the
SYSMEM circuit pack that is running in the FT-2000 network element.
8. STOP! YOU HAVE COMPLETED THIS PROCEDURE.
9. At the CIT, select FAULT-Reset and execute. During the reset time, the mis-
cellaneous discrete control points will be deactivated.
10. Wait 10 minutes or until the MJ LED is off at the user panel.
11. STOP! YOU HAVE COMPLETED THIS PROCEDURE.
To Next Page
Loading...