TAP-137: Trouble Clearing 365-575-102
Page2of2 Issue8.0,July2002
Nice to Know: If you are using Release 4.1 or later software, you can verify
that only one node is provisioned as the DS-NE by obtaining a Ring Map
Report (at the CIT, select CONFIGURATION-Retrieve-Map-Ring.Ifyou
are using Release 3 or 4.0 software, you must log in to each node in the ring
network to verify the yes or no DS-NE parameter value (at the CIT, select
CONFIGURATION-Retrieve-Network Element).
7. Log off from the network element.
8. Wait 5 minutes for the ring diagnostics to stabilize. After this time, the DS-NE
not reachable condition should be cleared.
9. STOP! YOU HAVE COMPLETED THIS PROCEDURE.
To Next Page
Loading...
Need help?
General