DLP-521: Detailed Level Procedure 365-575-102
Page 6 of 10 Issue 8.0, July 2002
24. STOP. YOU HAVE COMPLETED THIS PROCEDURE.
Quick Check for Typical Datakit Network
25.
NOTE:
The
Datakit
network supports many configuration parameters. Some
parameters are changeable by the user; others are set by the network
administrator. The user should consult local procedures in determining how
to configure their network. The manufacturer's manuals may be referred to
for specific instructions on setting the parameters.
NOTE:
The provisioned state (parameter settings) of the
Datakit
port to which the
user is connected may interfere with the successful interaction of the CIT
PC and the FT-2000 NE. This procedure allows the connection to be made
independently of the provisioned state of the
Datakit
port.
Press the key and momentarily wait for the response DESTINATION:.
26. Did you get the DESTINATION: prompt?
If YES, then continue with Step 34.
If NO, then continue with Step 27.
27.
NOTE:
The
Datakit
port (to which the PC is connected) is NOT supporting the
Datakit
command mode. Perform the following steps to allow the
connection to be made independently of the provisioned state of the
Datakit
port. This allows a method to connect to the CIT (DTE) port of an FT-2000
NE via a
Datakit
network.
Put the PC into a terminal emulation mode and send the "attention sequence"
which is usually provisioned to be two BREAK characters. [Check with the
Datakit
network administrator for the local attention sequence character(s).]
28. Did the
Datakit
port respond with Command:?
If YES, then continue with Step 31.
If NO, then continue with Step 29.
ENTER
To Next Page
Loading...
Need help?
General