Craft Interface Terminal Usage
11-28 Issue 8.0 July 2002
PERFORMANCE-
Initialize
-PM Initializes the performance-monitoring storage
registers (to zero).
CONFIGURATION-
Initialize
- System Causes current values in the SYSMEM to be
replaced by the original values in the SYSMEM
and then restarts the software.
FAULT-
Operate
-Alarm Cutoff Silences the office audible alarms.
FAULT-
Operate
-Loopback-EC1 Executes a loopback on an EC1 port in the
direction towards the OC-48 line.
FAULT-
Operate
-Loopback-OC3 Executes a loopback on an OC3 slot in the
multiplex direction (towards the OC-48 line) or
demultiplex direction (towards the low speed
cross-connect panel).
FAULT-
Operate
-Loopback-OC12 Executes a loopback on an OC12 slot in the
multiplex direction (towards the OC-48 line) or
demultiplex direction (towards the low speed
cross-connect panel).
FAULT-
Operate
-Loopback-T3 Executes a loopback on a DS3 port in the
direction towards the OC-48 line.
FAULT-
Release
-Loopback-EC1 Releases a loopback on an EC1 port.
FAULT-
Release
-Loopback-OC3 Releases a loopback on an OC3 slot.
FAULT-
Release
-Loopback-OC12 Releases a loopback on an OC12 slot.
FAULT-
Release
-Loopback-T3 Releases a loopback on a DS3 port.
FAULT-
Reset
Restarts the FT-2000 network element software
as follows: (1) Current memory values are copied
from the SYSCTL to the SYSMEM, (2)
executable code is copied from the SYSMEM to
the SYSCTL, (3) the executable code in the
SYSCTL is restarted, and (4) the current values
in the SYSMEM are reformatted as necessary to
work properly with the executable code running in
the SYSCTL.
SECURITY-
Retrieve
-Active User Allows a user to retrieve the current CIT and TL1
port provisioning and who is currently logged into
each port.
FAULT-
Retrieve
-Alarm (and Status) Generates an active alarm and status report on
the FT-2000 System.
CONFIGURATION-
Retrieve
-
Assignment-DCC
Retrieves the DCC channel assignment to the LS
INTFCslotorpairofslots.
CONFIGURATION-
Retrieve
-Attribute-
Alarm
Retrieves the alarm attributes for the FT-2000
network element.
Table 11-8. Input (Command) Definitions (Contd)
Selected Input Purpose
To Next Page
Loading...