Lucent Technologies FT-2000 OC-48 - Page 740

Craft Interface Terminal Usage
11-32 Issue 8.0 July 2002
CONFIGURATION- Retrieve -Synchroniz
ation
Retrieves provisioning and operational
information and the attributes of the
synchronization characteristics of the FT-2000
terminal.
CONFIGURATION-
Retrieve -T3 Retrieves provisioning information on the
attributes if a DS3 port.
CONFIGURATION-
Retrieve -Timeslot-
STS1
Retrieves Tributary Map Report, organized by
node, for all nodes in a ring. The report shows all
cross-connections on a single user-specified time
slot throughout the entire ring, indicating parts of
the ring available for new circuits.
CONFIGURATION-
Retrieve -Timeslot-S
TS3
Retrieves configuration information on an
FT-2000 Add/Drop-Rings Terminal.
CONFIGURATION-
Set -Attribute-Alarm Provisions the alarm attributes of the FT-2000
terminal.
CONFIGURATION-
Set -Attribute-Control Provisions the character strings associated with
the miscellaneous discrete control output points.
CONFIGURATION-
Set -Attribute-
Environment
Provisions the character strings associated with
the miscellaneous discrete environmental input
points.
CONFIGURATION-
Set -Date Provisions the correct time, calendar date, and
time zone.
CONFIGURATION-
Set -EC1 Provisions the characteristics of an EC1 port.
SECURITY-
Set -Far End
Communications
Provisions the control of the far-end
communications access to the FT-2000 terminal
over the DCC.
SECURITY-
Set -Login-Change Only a privileged user can make changes to the
provisioned login parameters (which are new
login, password, verify password, user privilege,
and status).
SECURITY-
Set -Login-Delete Only a privileged user can delete the provisioned
nonprivileged user logins.
SECURITY-
Set -Login-Enter Only a privileged user can provision the login
parameters (which are new login, password,
verify password, and user privilege).
CONFIGURATION-
Set -Low Speed Provisions the protection switch priority and the
equipage dependent reporting capability of a
low-speed slot.
SECURITY-
Set -Network Element Provisions the FT-2000 network element
identification (TID).
Table 11-8. Input (Command) Definitions (Contd)
Selected Input Purpose