Craft Interface Terminal Usage
Issue 8.0 July 2002
11-173
55. Select CONFIGURATION-Retrieve-T3 and then press .
56. Enter "All" (without quotes) for Slot and then press .
57. Press function key to execute.
58. Refer to the report displayed on the CIT screen and note that the port has
been set to NMON. Only the first line of the report should match. The
remaining lines may differ slightly.
59. Notice the message line at the bottom of the screen is waiting for a "yes" or
"no" entry if Paging was set to on during SET-UP.
60. Press the key for yes. Notice the report is scrolling one more
page.
ENTER
ENTER
F9
ENTER
To Next Page
Loading...