Procedure
B-10 Web Installation on the Database Server
If there is a reply from that hostname and can be resolved to the proper IP Address,
the LAN connection has been made.
If the ping fails, the reason for the failure will be shown. Identify the problem,
correct it, and repeat the process.
Step 2. Access patient data on the Database Server to verify that the Information Center Web
is functioning properly. This should be done from a PC on the hospital’s intranet, but it
can be done from the Database Server.
Note At least one Information Center on the Network must be monitoring patients for patient data to
be available for reviewing.
If accessing Server data from a PC on the hospital’s intranet:
• Open the web browser to be used.
• Enter the following URL: http://IP Address, where IP Address is the IP Address of the
NIC set in Entering the NIC IP Address, press Enter, and the Information Center
Web
TM
Login window will display.
• Log in using the account that was added in “Web User Access Config Tool” on
page B-6
• Assign a new user and password
• Log out and log back in using the new user
• Verify patient lists and data from all Database Servers are present
Note The URL can also be the Host name of the Server if the hospital LAN’s DNS and/or WINS
(Dynamic Name Server) is properly configured. However, if there are multiple Servers on the
LAN, each Server’s Host name must be unique.
If accessing Server data from the Database Server:
Note Accessing patient data from the Database Server should only be done for testing Information
Center Web performance. It is not supported under normal operating conditions.
• Access the Service window.
• Click on Network Statistics in the Support Logs menu to open the Network
Statistics window.
To Next Page
Loading...
Need help?
General