Strasbaugh nTellect 7AF - Page 1474

STRASBAUGH, INC.
5-24 February 19, 2002 7AF SECS/GEM Interface Ver. 1.9
Strasbaugh Confidential
5.7.1.7 PP-SELECT
The Host can initiate a new lot by sending this command. This command will select a process program for the current lot
and also assign the lot a name.
S2F41 [W]
<L [2]
<A 'PP-SELECT'>
<L
<L
<A 'LOTID'> * CPNAME
<A LOTNAME> * name for the Lot
>
<L
<A 'PPID'> * CPNAME
<A PPNAME> * Process Program name
>
>
> .
5.7.1.8 BEGIN-AUTO
The Host can set the 7AF to Process State 2 to enable the grinding process.
S2F41 [W]
<L [2]
<A ‘BEGIN-AUTO’>
<L>
> .
5.7.1.9 GRIND-TYPE
This command sets the grind type on the 7AF. The valid choices for GTypeName are FINE, COARSE and DUAL.
S2F41 [W]
<L
<A 'GRIND-TYPE'>
<L
<L
<A ‘GTYPE’>
<A GTypeName>
>
>
> .
5.7.2 Related Variables
The following table lists the variables (SV's, EC's, or DVVALS) which are relevant to remote control. For a more
complete description of these variables, see "Appendix A -- Variables".
Table 21 Remote Control Related Variables
Variable Name VID
PREVIOUSCOMMAND 18