Strasbaugh nTellect 7AF - Page 1496

STRASBAUGH, INC.
6-6 February 19, 2002 7AF SECS/GEM Interface Ver. 1.9
Strasbaugh Confidential
ONLACK Description
0x00 OK. Equipment On-Line transition successful.
Equipment Control State transits to either Local or
Remote while On-Line as guided by the EC
"GemOnlineSubstate".
0x01 On-Line not allowed.
0x02 Equipment already On-Line.
6.15 S1F65 - Connect Request
Note: This message is provided only for compatibility with Host computers which support an older version of GEM.
The Equipment Constant ConfigConnect can be set to cause the Equipment to send S1F65 instead of S1F13 for Connect
Request.
The Equipment sends this message using the following format:
S1F65 W * H<-E
<L
<A MDLN>
<A SOFTREV>
> .
Format 1: The Host sends this message using the following format:
S1F65 W * H->E
<L> .
Format 2: The Equipment also accepts the following form of this message:
S1F65 W . * H->E
Either end of the link may send S1F65 as the first message to establish connection of the link.
Under the 7AF's initialization logic, the Equipment will always attempt to establish the link. If no Host acceptance reply
is received, the Equipment sends this message periodically.
6.16 S1F66 - Connect Request Acknowledge
Note: This message is provided only for compatibility with Host computers which support an older version of GEM.
If the Host sends S1F65, Format 1, the Equipment replies S1F66 using the following format.
S1F66 * H<-E
<L
<B [1] 00> * COMMACK
<L
<A MDLN>
<A SOFTREV>
>
> .
If the Host sends S1F65, format 2, the Equipment replies S1F66 using the following format.