Operations and Maintenance Manual Operator Functions
Version 1.2 - June 2004 8 - 61
IF THERE'S A PROBLEM, STOP (CANCEL) THE CYCLE
13. If at any time during the cycle you observe a problem or potential problem,
stop the cycle immediately by touching Stop Cycle button on the menu
screen:
Operator Action Explanation/Screen Display
a. Stop Cycle Touch the "Stop Cycle" button to cancel the
cycle.
b. Correct the problem condition.
c. Return to Step 1., above in this section, to begin the cycle again.
WHEN THE START CYCLE AND STOP CYCLE BUTTONS BEGIN TO FLASH
14. When the Start Cycle and Stop Cycle buttons begin to flash, indicating the
procedure has been completed, touch the Stop Cycle button:
Operator Action Explanation/Screen Display
• Stop Cycle Touch the "Stop Cycle" button.
15. Remove the dressing disc:
a. Open the operator access door.
b. Remove the dressing disc from the work chuck.
c. Close the operator access door.
16. Reference the machine:
• Following the procedures found in the Basic Operation section of this
chapter, reference the machine.
To Next Page
Loading...
