Strasbaugh nTellect (Model 7AF) Wafer Grinder
8 - 66 Version 1.2 - June 2004
IF THERE’S A PROBLEM, STOP (CANCEL) THE CYCLE
11. If at any time during the cycle you observe a problem or potential problem,
stop the cycle immediately by touching Stop Cycle button on the menu
screen:
Operator Action Explanation/Screen Display
a. Stop Cycle Touch the "Stop Cycle" button to cancel the
cycle.
b. Correct the problem condition.
c. Return to Step 1., above in this section, to begin the cycle again.
WHEN THE START CYCLE AND STOP CYCLE BUTTONS BEGIN TO FLASH
12. When the Start Cycle and Stop Cycle buttons begin to flash, indicating the
procedure has been completed, touch the Stop Cycle button:
Operator Action Explanation/Screen Display
• Stop Cycle Touch the "Stop Cycle" button.
13. Reference the machine:
• Following the procedures found in the Basic Operation section of this
chapter, reference the machine.
To Next Page
Loading...
