Operations and Maintenance Manual Introduction
Version 1.2 - June 2004 1 - 5
CONTROL PANEL - OPERATOR AND MAINTENANCE PROCEDURES
Characters in all caps in angled brackets ("<", ">") represent a single push button
on the control panel.
Example: <MACHINE ON> is the symbol used for the Machine On push
button in procedures shown in this manual.
AT THE PC KEYBOARD - MAINTENANCE PROCEDURES
For commands entered at the keyboard, this manual is designed, as much as
possible, in a two-column format with commands to be entered or typed located in the
left column. Information is placed in the right column.
Characters in angled brackets ("<", ">") represent a single key on the keyboard.
Example:
You Press or Type Explanation/Screen Display
dir <Enter> Type "dir" and press the Enter key to confirm.
Type a “.” (decimal point) on the PC keyboard by using the decimal on the numeric
keypad.
STEP-BY-STEP INSTRUCTIONS
Instructions for all procedures are given in numbered steps. Steps may be numbered 1,
2, 3; a, b, c; or i, ii, iii.
To Next Page
Loading...
