Operations and Maintenance Manual Mechanical Maintenance Procedures
Version 1.2 - June 2004 11 - 43
VI. ADJUST THE LOWER LEFT SPINDLE ASSEMBLY TO A POSITION
PARALLEL
WITH THE UPPER SPINDLE ASSEMBLIES
Tools Required
• 3/4-in. open end wrench
• 9/16-in. open end wrench or 1/4-in. hex key
UPPER LEFT SPINDLE
Note:
At the end of the procedure above (Adjust the Upper Spindle Assemblies to Positions
Parallel with the Lower Right Spindle), the upper left spindle should still be positioned
above the lower left spindle and the probes should still be down.
To Next Page
Loading...
