Strasbaugh nTellect (Model 7AF) Wafer Grinder
11 - 148 Version 1.2 - June 2004
10. Retest by repeating Steps 1. and 2. in Section B., above.
a. If the goals are met for both switches, skip to When Satisfactory
Adjustment Is Achieved, below.
b. If either goal is not met, repeat the adjustment procedure, moving the
affected switch toward the middle of the cylinder in 1/8-in. increments,
moving the switch(es) and retesting until the goal is met.
D. WHEN SATISFACTORY ADJUSTMENT IS ACHIEVED
1. Replace door 10.
2. Power up and home the machine.
To Next Page
Loading...
