Strasbaugh nTellect (Model 7AF)Wafer Grinder
2 - 4 Version 1.2 - June 2004
STEP 1 - UNPACKING/INSPECTION
The Model 7AF Wafer Grinder is shipped from the factory in one unified section--with
the grinding area and wafer handling area bolted together in the machine operation
configuration. The handling section is attached to the grinding section by a hinge at
the left side of the machine and two 3/8-16 setscrew/wing nut sets located at the right
side of the machine, as viewed from the front.
The machine is wrapped in one or more layers of plastic (to prevent contamination
during shipping) and fastened to a shipping pallet. Before unpacking the machine from
its shipping provisions, inspect the exterior carefully for any indication of possible
shipping damage. If such signs exist, contact the shipper to report a claim and obtain
additional instructions before proceeding.
For details on the machine cabinet and the door numbering system, refer to the
Physical Description chapter of this manual.
To Next Page
Loading...
