Strasbaugh nTellect (Model 7AF) Wafer Grinder
12 - 4 Version 1.2 - June 2004
MENUS USED IN MAINTENANCE AND
CALIBRATION
CAUTION! The functions at the Machine Maintenance, Input Control/Output
Status, and Machine Setup Entry menus should be used only by
trained service personnel.
MACHINE MAINTENANCE MENU
Manual Control of Assemblies
The Machine Maintenance menu, selected at the Main Menu, provides selective
manipulation of machine components when performing maintenance and adjustment
procedures.
Diagnostic and Calibration Menus
In addition, buttons at the bottom of the Machine Maintenance menu access two
diagnostic and calibration menus, the Input Control/Output Status menu and the
Machine (Calibration) Setup Entry menu.
Follow the procedure below to display the Machine Maintenance menu:
Operator Action Explanation/Screen Display
Machine
Maint At the Main Menu screen, touch the "Machine
Maint" button to select the Machine Maintenance
menu.
The screen displays the Machine Maintenance menu,
shown below.
To Next Page
Loading...
