Operations and Maintenance Manual Installation
Version 1.2 - June 2004 2 - 15
15. Adjust the leveling feet until the goal is met:
a. Using a 15/16-in. open end wrench, rotate the locking nut of each locking
nut and adjusting bolt pair counterclockwise to loosen.
b. Using a 3/8-in. open-end wrench, rotate each hex head adjusting bolt
counterclockwise or clockwise (up or down) as needed to meet the goal.
c. Retighten the locking nuts by rotating them clockwise to firm.
16. Recheck the adjustment:
a. Repeat Step 14., above.
b. If needed, repeat the adjustment procedure until the goal for Side to Side at
the Rear is met.
Final Check
17. Reconfirm that the goals for the Right Side, above, are met.
If needed, repeat the adjustments.
18. Reconfirm that the goals for the Left Side, above, are met.
If needed, repeat the adjustments.
19. Reconfirm that the goal for Side to Side at the Rear, above, is met.
If needed, repeat the adjustments.
20. When the goals for Right Side, Left Side, and Side to Side at Rear have been
met, go on to Section B., Handling Area Cabinet Base Leveling Procedure,
below.
To Next Page
Loading...
