Firmware Version 3/4.31.37
4/9/12 MSH
Added archiving of Lua chunks to flash along with transaction in UAP builds.
Changed logic of TDS thread to allow processing of lower priority tasks even if
higher priority tasks fail.
4/13/12
Added Modem init string to General Setup screen.
UAP development:
Replaced Modem Init String and Modem Dial String with Terminal ID and Bay ID.
(Modem parameters to be dropped when UAP included in all ML Builds)
Replaced meter_type field with disabled on the preset table.
Added supplier number to UAP terminal_profile and preset_authorized_products
tables.
Added processing of UAP disabled fields in Bay, Meter and Preset tables.
Added handling of compartment required fields on Bay and Terminal Profile
tables..
Added LUA parsing of bay_id and term(inal)_id configuration parameters into LUA.
Added lookup and error handling for terminal_profile and bay table records.
Updated UAP product authorizations to use terminal supplier number.
Updated LUA goto, find and product authorization logging.
Added logic to exclude saleable products from preset authorized products is the
base components or additives are not present on the additive.
Added logic to abort LUA processing when a LUA script error occurs.
4/21/12 WJP
UAP Development:
Updated simulation build of network_get_mac_address() to get MAC address of
host PC.
Removed Terminal ID and Bay ID from configuration and from prompt script
startup variables.
Added LUA mac_address startup variable.
Changed prompt script to look for the Bay record by using the device IP address.
Added device address to the "Bay not Found" Message Denied.
Added tds_client to Driver find.
Corrected bug where no pin required, would skip Driver validation.
Added tds_client and term_id to Carrier picklist and find.
Renamed PromptVehicle to PromptTruck.
Added tds_client to Truck find.
Added tds_client to Trailer find.
Added ability to find on five fields.
Correct bug in find routines where search would be aborted if first record was
greater than search record.
4/23/12 MSH
Beta release to QA
UAP Development:
Add support for card reader when in UAP mode.
Added ability to clear records in individual/all databases.
Updated transaction payload for communication with TDS.
BOL reprint logic added to prompting sequence.
4/25/12 MSH
Fix issue where ML would hang/reboot in multidrop and miswired/not connected.
5/8/12 WJP
Corrected bug where loss of only the RX line from an FCM will prevent flow
termination and dropping of all outputs after 6 seconds.
To Next Page
Loading...