Firmware Version 3/4.31.37
UAP, TMS and MultiMate uploads of Driver Card Number data should be zero padded
before uploading.
UAP, TMS and MultiMate should be updated to support alphanumeric (hex) data for
ibutton support.
TMS needs to be updated to support the following card reader types for
MultiLoad/SMP:
#define CARD_READER_TYPE_DISABLED 0
#define CARD_READER_TYPE_BUCKET_CAPTIVE 1
#define CARD_READER_TYPE_BUCKET_NONCAPTIVE 2
#define CARD_READER_TYPE_SLOT_CAPTIVE 3
#define CARD_READER_TYPE_SLOT_NONCAPTIVE 4
#define CARD_READER_TYPE_IBUTTON 5
04/29/2013 PS
Increased firmware number to x.31.11 for Mass changes
05/01/2013 PS
Added Raizen Logo
05/03/2013 PS
Added new feature that prompts1 to 4 can be used in custom logic (remark entry
value will stay, until next driver enter new value)
Added new feature that Alibilog can print all 5 prompts when they are not blank,
prompts can contain any data.
Also added 5 new alibilog labels for the 5 prompts, default names are
Stockholder,Customer,Account,Destination,Driver.
05/04/2013 PS
Added new fifth standalone Prompt, updated all protocols, can be also used on
standalone BOL.
Enhancement all prompts are getting clear at the end of the load, only in
standalone mode.
Added new feature that output pulse on Preset Level can also be Mass
05/06/2013 WJP
Update UAP Set_Max_Preset() routine to ignore limit when Max Load Qty from TDS is
0 or blank.
05/9/2013 WJP
Added debug code to assist with incorporating new TFT displays.
Added TEST_NEW_DISPLAY precompiler flag to force display of the display
diagnostic screen on power up.
Added a screen to adjust and apply changes to the display parameters when the
TEST_NEW_DISPLAY precompiler flag is defined.
05/11/2013 PS
Enhancement of Custom Logic added analog in , analog out and RTD input for only
FCM2.
Added also to Modbus as other protocols.
To Next Page
Loading...