Firmware Version 3/4.31.37
Added to Diagnostic Mode.
Added check if analog output is already used by meter level for valve control.
05/14/2013 PS
Added Canexus Logo
Added Alarm Output for each alarm on global alarm level
05/15/2013 PS
Enhancement on Custom Logic:
Each Alarm Level Bay, Preset, Meter, Component and Additive can be used for a
certain/specific Bay, Preset, Meter, Component and Additive.
Also added this to all communication protocols as Modbus.
05/16/2013 PS
Added 2 new API tables for Alcohol, these tables use temperature and density as
an input and will give the alcohol percentage of the product.
05/17/2013 PS
Change German Ethanol table from temperature hundredths to tenths mode.
Added totalizers to UAP Bol.
05/18/2013 PS
Added new feature to mask the storage of an alarm. Results in tot storing,
printing the alarm.
Update communication protocols.
05/18/2013 PS
Added density air for less than 996.6 (1.1 kg/m3), range 996.6 to 1663.5 (1.0
kg/m3) and greater than 1663.5 (0.9 kg/m3)
05/30/2013 WJP
Added simulation control web page to allow:
Change meter simulation between Auto, Force Flow and Hold Flow.
Change additive simulation between Auto, Force Flow and Hold Flow.
Change input port simulation between Auto, Force On and Hold Off.
05/30/2013 WJP
Added CTL and CPL display on the component status screen and api table setup
screen.
Update CN code to work with previous card_id parameter change.
06/15/2013 WJP
Corrected Weighted Average Routine for Temp, Density, Rel. Density, Pressure,
Gravity, BSW where negative values were always computed as one least significant
unit lower than actual at the component level (-0.01 temp for example) and two
least significant units lower than actual at the preset level (-0.02 temp for
example).
To Next Page
Loading...