Firmware Version 3/4.31.37
Removed battery calculation for compensation and removed displaying this value.
11/08/2013 PS
Added new help screen with description for Rcu, Bay, Preset, Meter, Component,
Additive and Trace level. Also added value, minimum, default and maximum value to
screen.
When selecting min, default or max value this value will be copied into config
value.
Enhanced code for multilingual support.
11/18/2013 PS
Help supports English, French and Portuguese.
Added audit trail logging. New screen to see the last 500 changes and added the
ability to store these change to the SD-Card by day.
Also purge older audit logs after 90 days on the sd-card.
Screens as all communication protocols will go into audit trail if level is
mentioned below.
Following levels are going into the audit trail:
Rcu,Bay,Preset,Meter,Component,Additive,Trace. Excluding the General Setup
registers and Communication setting registers.
Added support to see Audit Trail on Webpage.
Added R913 register to support reading of audit trail real-time.
Added in Custom Logic the state of the RCU.
Fix: RCU Setup screen the language selection puts the cursor on the next line.
11/19/2013 PS
Added FCLEARAUDIT to clear the config change log.
11/25/2013 PS
Enhancement custom logic split date and time field into year, month , day, hour,
minute and seconds.
Added to custom logic the Julian date formula, for calculating the elapsed days.
11/26/2013 PS
Enhancement custom logic with adding the Epoch time.
Enhancement of custom logic to use set_value between -2147483647 to +2147483647.
If higher the screen will indicate this.
Enhancement of custom logic added an up/down counter with reset (all raising
edge) and added a flip-flop/latch on clock.
Added these 2 new custom logic types to all protocols and Modbus.
Fix: If totalizer flag is set and more than 1 product is printed, all other
products are missing on the ticket printing.
12/12/2013 PS
Fix: 1980 23E was not calculating pressure correction factor.
Fix: API Calculator pressure input goes to the next line of the screen.
12/12/2013 TF
Added FCM mapping report feature that displays how each port of each FCM is
configured. Viewable on the MultiLoad screen, via web interface, and capable of
sending to a printer.
Added FCM type setup screen which allows the user to configure the type of FCM
for each one configured in MultiLoad. By default the type is left blank.
Enhancement 6DCIN FCM tester routine for new pogo pin FCM tester prototype.
Fix: FCM temp module type max value was out of range, changed from 19 to 13.
12/13/2013 PS
Enhanced 2007 E-tables with CPL calculation (GPA TP-27 2007).
To Next Page
Loading...