Firmware Version 3/4.31.37
3/19/2014 PS
Fix: SD-Card Menus were not showing correct filename link, only internal build
was affected.
Fixed compiler warnings int versus unsigned int and also added some extra range
checking.
Enhance Custom Logic delays, timers if the time value is negative we force it to
zero.
3/25/2014 PS
Fix: For firmware 3.31.14 the set value in custom logic was always giving an out
of range error.
3/26/2014 PS
Enhancement RCU Setup screen with auditlog. UAP settings are excluded.
Enhancement of Passwords: 1/Minimum length of 5. 2/Password changed recorded in
Auditlog. 3/Add bottom bar messages to indicate changes.
4/The password change for all communication protocols will go into the auditlog.
3/27/2014 PS
Make it possible to send the auditlog to a serial printer or network printer.
Enhancement of auditlog to more screens and communication parameters.
Enhancement that all alarm parameters are going into the audit log.
Enhancement if alarm parameter changes not all sub parameters for that alarm are
getting logged.
Fix: Update Alarm Component Level would not store alarm_to_host,
alarm_output_fcm, alarm_batch_mask.
3/30/2014 WJP
Removed 3po task handler and added to background processing routine.
Added DIGITAL_PATH POC code.
4/02/2014 PS
Added German help.
Increase upload buffer for firmware to 20Mb.
4/03/2014 PS
Fix: When Tms is sending a header bar we should color the line to the end of the
screen.
4/21/2014 PS
Added to Custom Logic Preset Level the active product code, lead component
number, additive state, missing injections, unauth gross additive, creep gross
additive.
Fix: Deadman inputs were not working in simulation mode.
Enhancement added start transaction and stop transaction configuration input, can
also be used in custom logic.
Added Analog Additive type which can control between 0 and 20mA, also help is
adjusted.
Added Default Driver Number and Default Facility Code. Default Driver Number and
Default Facility Code is always used unless remote processing AND the card reader
is disabled
Added help for these 2 parameters.
Updated Order Database for UAP.
4/28/2014 PS
Added default driver and default facility number to Custom Logic.
To Next Page
Loading...
