Firmware Version 3/4.31.37
Enhancement: Added new Sampler feature.
7/15/2014 PS
Fix: SMP and SCS build Preset Control Screen bottom bar was wrapping.
Fix: UAP Bol script alignment issue with Configurable Prompts.
Fix: UAP alignment issue with Configurable Prompts on MultiLoad screen.
Enhancement: Only allow on the webserver TLSv1 SSL communication. (SSL2 and SSL3
are disabled)
Enhancement: Network Screen got new sub menus for SSL security.
7/22/2014 MTS
Enhancement: Provide human readable descriptions of rejected params on SD card
load.
7/22/2014 MTS
Fix: Widen BS&W tolerances +/- 10%.
7/23/2014 MTS
Enhancement: Custom Logic breakout of Totalizers.
Enhancement: Custom Logic breakout of Reset Totalizers.
Fix: Transaction reprint logic "header_index" correction.
7/17/2014 PS
Added tank configuration parameters.
Added tank configuration and network configuration storage on sd-card.
Added 32 Tank Alarms to alarm table.
Added input/output port configuration for all tank fcm parameters.
Added new tank configuration R/U111 parameters to communication protocol.
Added number of tanks to bay level configuration.
Added R715 Register for tank alarm messages.
Added Real-time tank alarm parameters.
Added Real-time tank level parameters.
Added tank alarms into custom logic.
Added tank cfg read/write into custom logic.
Added tank real-time values into custom logic.
Added tank group to component level.
Added tank name to R/U402 register.
Added Diagnostic Screen for Tanks Permissives.
Added default tank names.
Added Preset tank alarm for cascading alarms, so the load stops.
Added Tank Product submenu for changing Tank Name.
Added Tank Alarms to alarm viewer.
Added Error checking Network and Tank parameters at bootup.
Added check on component level that tank group is existing.
Added custom logic Modbus register for tank alarm, config and real-time values.
Added Tank Alarms to preset status screen.
Added to FCM Report the tank I/O.
Added to Configuration Report Tank configuration values.
Added Tank Group to additive level.
Added help for all new configuration parameters.
Added Tank Trace Config.
Added Tank Valve Open and Close, also added tank valve status.
Added Open and close delay alarm timeout with Tank Valve alarm.
Added Tank Mode for Loading and Unloading.
Added Product to Tank. Also added check to insure tank product matches preset
product.
Refactor + cleanup Network Routines.
To Next Page
Loading...
