Firmware Version 3/4.31.37
7/26/2014 PS
Enhancement: Added the possibility to configure 4 Ntp-servers with gmttime offset
parameter.
Enhancement: File changes on the sd-card will also have no the correct date and
time.
7/28/2014 PS
Enhancement: Added DNS-Server for Host IP Address and for all Printer IP
Addresses.
7/29/2014 MTS
Enhancement: Modify Preset params from Min/Max/Default Preset Volume to Value.
7/28/2014 PS
Enhancement: Added DHCP Mode to get IP-addresses(Its own, gateway, subnet mask,
broadcast) for DNS IP Address.
Changed network enabled parameter to network mode parameter.
7/29/2014 PS
Remove modem_init and modem_dial.
7/29/2014 TF
Enhancement added Diverter logic
- opens/closes a diverter valve to ensure proper BSW levels.
- New parameters added Divert Valve FCM#, Divert Time Start, Divert Time
Restart, BSW Divert Alarm Time, BSW Stabilization Time.
- The BSW Stabilization Time is used to account for oscillating BSW values. If
a BSW value is changing from good to bad,
or vice versa, we wait for it to stabilize before we decide that a value has
changed states.
Enhancement added the ability to reset Factory Defaults from the Program Mode
screen.
Fix when saving prompts to prompt file, MultiLoad will only write prompts that
are available for that build. Previously MultiLoad was saving all of the prompts,
so MultiMate was displaying prompts that were not available for builds such as SMP,
SCS, etc.
7/29/2014 PS
Fix: Help changed for Temp Module Typ. Now says that it needs to be set to 3 if
you want to us an external analog input on FCM2.
Fix: Sd-Card Screens were not going out of program mode when program mode timer
expired.
Enhancement: If network screen is in DHCP Mode we will show all the DHCP IP-
Addresses.
The Host IP Address will be resolved if needed, but the name can still be changed
when entering the parameter.
7/30/2014 PS
Added to Network Screen a reboot network option to renew DHCP.(renew of DHCP is
only during power cycle)
7/31/2014 TF
Added Transaction Report that can be exported to the SD Card, and accessed via
the web interface
Added a Divert BSW Value parameter for the diverter logic.
Added a Divert Alarm that is triggered, when the BSW value stays above the Divert
BSW value for a length of time.
Fix so MultiLoad will not go into Low Flow Alarm while Diverting.
To Next Page
Loading...
