Firmware Version 3/4.31.37
07/13/2015 TF
Added a new Firmware Info screen to Views & Inquiries menu.
Display the firmware checksum on the bootup screen.
07/23/2015 WJP
Corrected a bug in the UAP ticket reprint function that would prevent reprinting some
tickets.
Added ticket printing of start totalizers on transactions.
08/21/2015 TF
Increased firmware version to x.31.25
Added French translations to the Help files.
Fixed some French translation inconsistences on some of the screens.
08/28/2015 TF
Increased the firmware version to x.31.26
Increased NR Database version to 3.31.26
Increased NR5 (Transaction) Database version to 3.31.26
Increased the NVRAM BLOCK SIZE for NR1. This will cause the user's totalizers to be
erased during an upgrade.
Added new Sampler Batch Reports Functionality for SCS:
- Any Driver can be given special access to create/end a sampler batch. In standalone
mode the parameter is located in Main Menu->Configuration Menu-> Access ID's->
(Select an ID)->Sampler Batch Access.
- Added a new View Sampler Batch screen in the Views & Inquiries Menu. The user can
view the last 12 sampler batch reports that have been run.
- A sampler batch is ended when the driver card, with the special access enabled,
cards in. When they card in, the End Sampler Batch screen is displayed along with a
picklist of all the different samplers. Once the batch is ended, it is assigned a
reference number and the next batch is started.
- Sampler Batch Reports can also be ended during an active transaction. If a
transaction is active, the user navigates to the Sampler Status screen and then
presses ENTER. Once that has been done, the MultiLoad will prompt the user for a
Driver Number and a PIN number. If the user enter a valid Driver/PIN then he will be
brought to the End Sampler Batch screen.
- It is also possible to setup automated Batch Reports. The user can setup a Monthly
and a Daily automated batch report, by going to the Reports Setup Menu.
- Once the report has finished being generated, a summary of the report will be
displayed on the screen. This summary can be sent to a printer if one is configured.
- The detailed report is saved in a .csv file onto the SD Card.
Added a new set of 16 bits for Special Access in the cards_def struct. It is possible to
use the next 15 bits for new features in the future.
Added the ability to export a Transaction Report in CSV format. It is now selectable from
the Export Reports Menu.
Added the ability to jump to the Export Reports Menu straight from the idle screen by
pressing "4446"
To Next Page
Loading...
