Managing Physical Interfaces Appendix: Default Parameters
Configuration Guide
105
8
Appendix: Default Parameters
Default settings of Switching are listed in th following tables.
Table 8-1 Configurations for Ports
Parameter Default Setting
Port Config
Type Copper
Status Enable
Speed Auto
Duplex Auto
Flow Control Disable
Jumbo Disable
Port Mirror
Ingress Disable
Egress Disable
Port Security
Max Learned MAC 64
Learned Num 0
Learned Mode Dynamic
Status Disable
Loopback Detection
Loopback Detection
Status
Disable
Detection Interval 30 seconds
Automatic Recovery Time 90 seconds
Web Refresh Status Disable
Web Refresh Interval 6 seconds
To Next Page
Need help?
General