Configuration Guide 70
Managing System SDM Template Configuration
6
SDM Template Configuration
SDM Template function is used to configure system resources in the switch to optimize
support for specific features. The switch provides three templates, and the hardware
resources allocation is different. Users can choose one according to how the switch is
used in the network.
6.1 Using the GUI
Choose the menu System > SDM Template to load the following page.
Figure 6-1 Configuring the SDM Template Function
In Select Options section, select one template and click Apply. The setting will be effective
after the reboot.
Current
Template ID
Displays the template currently in effect.
Next Template
ID
Displays the template that will be effective after the reboot.
Select Next
Template
Select the template that will be effective after the next reboot.
default: Select the template of default. It gives balance to the IP ACL rules, MAC ACL
rules and ARP detection entries.
enterpriseV4: Select the template of enterpriseV4. It maximizes system resources for
IP ACL rules and MAC ACL rules.
enterpriseV6: Select the template of enterpriseV6. It allocates resources to IPv6 ACL
rules.
To Next Page
Loading...
Need help?
General