Configuration Guide 722
Configuring SNMP & RMON RMON Configurations
Description Give a description to the event.
Type Specify the action type of the event; then the switch will take the specified
action to deal with the event. By default, the type is None.
None: No action.
Log: The switch records the event in the log, and the NMS should initiate
requests to get notifications.
Notify: The switch initiates notifications to the NMS.
Log&Notify: The switch records the event in the log and sends notifications to
the NMS.
3) Enter the owner name, and set the status of the entry. Click Apply.
Owner Enter the owner name of the entry with 1 to 16 characters. By default, it is
monitor.
Status Enable or disable the entry. By default, it is disabled.
Enable: The entry is enabled.
Disable: The entry is disabled.
5.1.4 Configuring Alarm
Before you begin, please complete configurations of Statistics entries and Event entries,
because the Alarm entries must be associated with Statistics and Event entries.
Choose the menu SNMP > RMON > Alarm to load the following page.
Figure 5-4 Alarm Config
Follow these steps to configure alarm:
1) Select an alarm entry, choose a variable to be monitored, and associate the entry with a
statistics entry.
Index Displays the index of alarm entries. There are 12 alarm entries all together.
To Next Page
Loading...
Need help?
General