Configuration Guide 546
Configuring Network Security IP-MAC Binding Configurations
Host Name Enter the host name for identification.
IP Address Enter the IP address.
MAC Address Enter the MAC address.
VLAN ID Enter the VLAN ID.
2) Select protect type for the entry.
Protect Type Select the protect type for the entry:
None: This entry will not be applied to any feature.
ARP Detection: This entry will be applied to the ARP Detection feature.
3) Select the port that is connected to this host.
4) Click Bind.
2.1.2 Binding Entries Dynamically
The binding entries can be dynamically learned from ARP Scanning and DHCP Snooping.

ARP Scanning
With ARP Scanning, the switch sends the ARP request packets of the specified IP field to
the hosts. Upon receiving the ARP reply packet, the switch can get the IP address, MAC
address, VLAN ID and the connected port number of the host. You can bind these entries
conveniently.
To Next Page
Loading...
Need help?
General