TP-Link T1600G-52PS - 7. Appendix: Default Parameters

Configuring LLDP Appendix: Default Parameters
Configuration Guide
671
7
Appendix: Default Parameters
Default settings of LLDP are listed in the following tables.
Default LLDP Settings
Table 7-1 Default LLDP Settings
Parameter Default Setting
LLDP Disable
LLDP Forward Message Disable
Transmit Interval 30 seconds
Hold Multiplier 4
Transmit Delay 2 seconds
Reinit Delay 2 seconds
Notification Interval 5 seconds
Fast Start Times 3
Table 7-2 Default LLDP Settings on the Port
Parameter Default Setting
Admin Status Tx&Rx
Notification Mode Disable
Included TLVs All
Default LLDP-MED Settings
Table 7-3 Default LLDP-MED Settings
Parameter Default Setting
Fast Start Count 4
LLDP-MED Status Disable
Included TLVs All