Managing System Access Security Configurations
Configuration Guide
57
5.1.2 Configuring the HTTP Function
Choose the menu System > Access Security > HTTP Config to load the following page.
Figure 5-2 Configuring the HTTP Function
1) In the Global Control section, Select Enable and click Apply to enable the HTTP
function.
HTTP HTTP function is based on the HTTP protocol. It allows users to manage the
switch through a web browser.
2) In the Session Config section, specify the Session Timeout and click Apply.
Session
Timeout
The system will log out automatically if users do nothing within the Session
Timeout time.
3) In the Access User Number section, select Enable and specify the parameters.
Number Control Select Enable to control the number of the users logging on to the web
management page at the same time. The total number of users should be no more
than 16.
Admin Number Specify the maximum number of users whose access level is Admin.
Guest Number Specify the maximum number of users whose access level is Operator, Power
User or User.
Note:
For T1600G-18TS, the number of Operator, Power User and User can be set respectively.
4) Click Apply.
To Next Page
Loading...
Need help?
General