Configuration Guide 392
Configuring Static Routing IPv4 Static Routing Configuration
2
IPv4 Static Routing Configuration
2.1 Using the GUI
Choose the menu Routing> Static Routing > IPv4 Static Routing Config to load the
following page.
Figure 2-1 Configuring the IPv4 Static Routing
1) In the IPv4 Static Routing Config section, configure the corresponding parameters to
add an IPv4 static route. Then click Create.
Destination Specify the destination IPv4 address of the packets.
Subnet Mask Specify the subnet mask of the destination IPv4 address.
Next Hop Specify the IPv4 gateway address to which the packet should be sent next.
Distance Specify the administrative distance, which is a rating of the trustworthiness of the
routing information. A higher value means a lower trust rating. When more than
one routing protocols have routes to the same destination, only the route that
has the shortest distance will be recorded in the IP routing table.
The valid values are from 1 to 255 and the default value is 1.
2) In the IPv4 Static Route Table section, you can view and modify the IPv4 static routing
entries.
To Next Page
Loading...
Need help?
General