Configuring Layer 2 Multicast Configuring MLD Snooping
Configuration Guide
309
3.1.2 Configuring the Port’s Basic MLD Snooping Features
Choose the menu Multicast > MLD Snooping > Port Config to load the following page.
Figure 3-2 Enable MLD Snooping on Port
Enabling MLD Snooping on the Port
Follow these steps to enable or disable MLD Snooping on the port.
1) Select the port to be configured and select Enable under the MLD Snooping column.
2) Click Apply.
(Optional) Configuring Fast Leave
With Fast Leave enabled on a port, the switch will remove this port from the forwarding
list of the corresponding multicast group once the port receives a leave message. Once
deleted, the switch will no longer send MASQs to this port to verify if there are other
members of this multicast group.
Follow these steps to configure fast leave.
1) Select the port to be configured and select Enable under the Fast Leave column.
To Next Page
Loading...
Need help?
General