TP-Link T1600G-52PS - Configuring Fast Leave

Configuration Guide 288
Configuring Layer 2 Multicast IGMP Snooping Configurations
Step 3 end
Return to privileged EXEC mode.
Step 4 show ip igmp snooping
Show the basic IGMP snooping configuration.
Step 5 copy running-config startup-config
Save the settings in the configuration file.
The following example shows how to configure the global router port time and member
port time as 200 seconds:
Switch#configure
Switch(config)#ip igmp snooping
Switch(config)#ip igmp snooping rtime 200
Switch(config)#ip igmp snooping mtime 200
Switch(config)#show ip igmp snooping
IGMP Snooping :Enable
Unknown Multicast :Pass
Last Query Times :2
Last Query Interval :1
Global Member Age Time :200
Global Router Age Time :200
Global Report Suppression :Disable
Global Authentication Accounting:Disable
Enable Port:
Enable VLAN:
Switch(config-if)#end
Switch#copy running-config startup-config
Configuring Fast Leave
Step 1 configure
Enter global configuration mode.
Step 2 interface {fastEthernet
port
| range fastEthernet
port-list
| gigabitEthernet
port
| range
gigabitEthernet
port-list
| port-channel
port-channel-id
| range port-channe
port-channel-list
}
Enter interface configuration mode