Configuration Guide 320
Configuring Layer 2 Multicast Configuring MLD Snooping
3.1.9 Configuring Static Member Port
This function allows you to specify a port as a static member port in the multicast group.
Choose the menu Multicast > Multicast Table > Static IPv4 Multicast Table to load the
following page.
Figure 3-10 Static Member Port
Configuring Static Member Port
Follow these steps to configure static member port.
1) Enter the Multicast IP and VLAN ID. Specify the Static Member Port.
Multicast IP Specify the multicast group that the static member is in.
VLAN ID Specify the VLAN that the static member is in.
Forward Port Specify one or more ports to be the static member port in the multicast group.
Without aging, the static member port receives all multicast data sent to this
multicast group.
2) Click Create.
Viewing MLD Static Multicast Groups
You can search MLD static multicast entries by using Multicast IP, VLAN ID or Forward Port
as the Search Option.
Static Multicast IP Table displays details of all MLD static multicast groups.
To Next Page
Loading...
Need help?
General