Configuration Guide 346
Configuring Layer 2 Multicast Configuration Examples
Enable IGMP Snooping in the VLAN. Demonstrated with T1600G-52TS, this section
provides configuration procedures in two ways: using the GUI and using the CLI.
5.1.3 Using the GUI
1) Choose the menu Multicast > IGMP Snooping > Snooping Config to load the following
page. Enable IGMP Snooping globally, and keep the default values in the Router Port
Time and Member Port Time fields.
Figure 5-2 Configure IGMP Snooping Globally
2) Choose the menu Multicast > IGMP Snooping > Snooping Config to load the following
page. Enable IGMP Snooping on port 1/0/1-4.
To Next Page
Loading...
