Configuring Layer 2 Multicast IGMP Snooping Configurations
Configuration Guide
277
2.1.6 Configuring IGMP Profile
With IGMP Profile, the switch can define a blacklist or whitelist of multicast addresses so as
to filter multicast sources, Choose the menu Multicast > IGMP Snooping > Profile Config
to load the following page.
Figure 2-6 Profile Create
Creating Profile
Follow these steps to create a profile and configure its filtering mode.
1) Create a profile and configure its filtering mode.
Profile ID Enter a profile ID between 1 and 999.
Mode Select Permit or Deny as the filtering mode.
Permit: similar to a whitelist, means that the switch only allows specified member
ports to join specific multicast groups.
Deny: similar to a blacklist, means that the switch disallows specific member ports
to join specific multicast groups.
2) Click Create.
Searching Profile
Enter the search condition in the Search Option field to search the profile in the IGMP
Profile Info table.
To Next Page
Loading...
Need help?
General