Configuring DHCP DHCP Client Configuration
Configuration Guide
409
2
DHCP Client Configuration
2.1 Using the GUI
Choose the menu Routing > Interface > Interface Config to load the following page.
Figure 2-1 DHCP Client Configuration
Follow these steps to configure DHCP client:
1) In the Creating Interface section, select Interface VLAN or Routed Port as the interface
type and enter the interface ID. Select DHCP or BOOTP as the IP Address Mode. Set the
Admin Status as Enable, and enter the Interface Name (optional).
Interface ID Select an interface type and enter the ID of the interface. If you select VLAN, enter
a VLAN ID. If you select Routed port, enter a port number.
IP Address
Mode
Select DHCP or BOOTP as the IP address assignment mode.
DHCP: Assign an ip address for the interface through DHCP.
BOOTP: Assign an ip address for the interface through BOOTP.
Admin Status Enable or disable the interface’s Layer 3 capabilities.
Interface Name (Optional) Specify a name for the interface.
2) Click Create.
To Next Page
Loading...
Need help?
General